Kilz Primer/Sealer

Kilz Original - Primer/Sealer/Stain Blocker
KILZ® ORIGINAL INTERIOR OIL-BASED PRIMER- Blocks out most stains including water, smoke, tannin, ink, pencil, felt marker and grease, and seals pet and smoke odours. Use on interior surfaces. Not recommended
on flooring.
WHERE TO USE:
Use on properly prepared interior surfaces, such as: Brick, Painted Metal, Properly Prepared Glossy Surfaces, Drywall, Paneling, Wallpaper, Masonry, Plaster, Wood.
PREMIUM APPLICATION TOOLS:
Airless Spray:
Tip: .015” - .021”
Filter: 60 mesh
PSI: Fluid pressure of 2,500 - 3,200
Roller:
Smooth Surfaces: 10 - 12 mm nap
Rough / Porous Surfaces: 12 - 14 mm nap
Brush:
Nylon / Polyester Blend or Premium
Natural Bristle
SURFACE PREPARATION:
• The surface must be clean, free of dust, grease,
wax, peeling paint, mold, mildew and wallpaper
paste. If washing is necessary, use a non-soapy
detergent or a TSP substitute. Rinse well and
allow to dry.
• Peeling or Checked Paint: Scrape off loose
paint and sand to a smooth surface. Sanding or
removal of paint containing lead is hazardous.†
• Glossy Surfaces: For maximum adhesion, scuff
sand the surface thoroughly before priming.†
• Mold or Mildew Covered Surfaces: Wash the
area with a mildew remover, rinse with water
and allow to dry before priming. Note: KILZ®
PREMIUM and KILZ 2® primers are recommended
for mildew-prone surfaces.
• Masonry, Brick, Stucco and Plaster: KILZ
ORIGINAL primer may be used on clean, dry,
aged masonry surfaces that have cured (dried)
at least 90 days. If masonry has been cured
less than 90 days, use KILZ® PREMIUM, KILZ
2® or KILZ ODOURLESS® primers.
• Fire Restoration: It is critical to clean smoke
damaged surfaces thoroughly before priming